LAND ROVER DISCOVERY II  RAINGLER LRBN INSTALLATION GUIDE
click images for larger view

1.     This install is fairly simple, but does require about an hour of time initially, and a little bit of easily obtained hardware.  Tools required: wrenches to fit 5/8” eye bolts and nuts.  Dremel tool to trim plastic opening slightly.

2.     Net will install with widest point on side just above rear seat headrests.  The label can be installed to the rear or front of the cab. [img. 1] The installation will use 6 factory location attachments and two owner supplied, installed upper mounts.

(img 1)

3.     Take down the rear side panels, trim or file out the hole to clear your eye bolts.  Attach the eye bolts to the factory mounts which will be very obvious when you take the panels down. [img. 2 and 3] You will need to place a nut on each side and adjust to get the eye bolt as flush as possible when the outside panel is mounted. A grommet may also be used to clean out the edge.

(img 2)


(img 3)

4.     Connect all other points around the net loosely, tighten to center it , then tighten the net as desired all over.  [img 4 and 5]

(img 4)


(img 5)