JK Side Window Installation 2007 and newer 2 door Wrangler JK  

CLICK IMAGE THUMBNAILS FOR LARGER VIEW 

  1. Verify that you have a matching (mirror image) set of windows.  The nets are designed so that the labels face outward - toward the lower rear area of the nets.  It is easier to remove the top or windows before installation.
  2. Install top forward strap across roll bar padding by depressing buckle and feeding angles strap into and through the buckle.  It may be tight and compressing the padding and pressing the straps ring as close as possible to facilitate as needed.
    (See image 1)
    installJK2dr1.JPG (123313 bytes)
  3. Install rear upper strap and wrap the bend area on the rear of the roll bar.  Do not tighten the strap yet.
    (See image 2)
    installJK2dr2.JPG (83123 bytes)
  4. Install rear lower strap under the rear seat belt retractor housing.  Pay attention as to not cause any interference with seat belts movement. Do not tighten this strap yet.
    (See image 3)
    installJK2dr3.JPG (110831 bytes)
  5. For 2-door JK Wrangler, install the lower forward strap positioning as low as possible. Do not tighten this strap yet.
    For 4 door JK Wrangler, install the footman loop brackets in approximate location as shown. (2 metal screws or bolts, not supplied, are required) Double check before drilling for proper clearances.  Install the lower forward strap positioning as low as possible. Do not tighten this strap yet    .
    (See image 4)
    installJK2dr4.JPG (106205 bytes) JKFLC.JPG (77866 bytes)
  6. Pull rear lower strap back across towards the rear of the vehicle.
    (as shown in image 5)
    installJK2dr5.JPG (104972 bytes)
    Feed excess web back through buckle opening and wrap and tuck as desired for a clean look.
  7. Pull the forward lower buckle as tightly as possible feeding the excess webbing into the plastic trim and working the buckle close to the roll bar as possible.
    (See images 6 and 7)
    installJK2dr6.JPG (83153 bytes) installJK2dr7.JPG (79089 bytes)
  8. Pull rear upper strap as to center and position net as desired.  It may be necessary to re adjust some buckles from earlier steps if net does not center as shown in final image 11.
    installJK2dr11.JPG (125532 bytes)
    Wrap and tuck straps as shown and repeat process for other side.

    Any questions contact us at offroadconcepts@gmail.com 
    Some netting pieces shown in images may not be included with your item ordered.
    Netting is not to be used as a replacement for the factory supplied restraint systems    . Always secure items in vehicle.